I found this 5/4 8" board at Farnsworth Lumber a couple months back. They threw it in the solar kiln for me and got it pretty dry so I started using it to make this valet last week. It's a continuous grain box with a drawer below (still working on that). The top is separated so there's a place for a phone. Spalted Maple Valet I was pretty happy with it when I was dry fitting it, but after glue up some slight gaps in the dovetails appeared and it went out of square by about 1/32". Not a huge deal but just annoying. Any sage advice for preventing these sort of problems? The dovetails were super tight before glue. Spalted Maple Valet Spalted Maple Valet