Notching and Tapering Cherry End Table Legs

I notched the legs, and then decided they needed a taper so went back and did that as well. I'm going to have to do a bit of sawdust clean up as there are some gaps here and there, but not bad for my first attempt at this.

I also dovetailed the drawers (you can see them on the bottom table's shelf). That was going great right up to the last of four cuts when my bit decided to drop 1/16" halfway through the cut. I caught it before I finished the cut but it left me with one ruined dovetail. I'll have to do some creative patching to fix it.

Comments

Pine Bin Organizer

More of a shop project (technically a basement project) but it's wood so I decided to post it up anyway. I've been looking for a bin organizer for awhile but I haven't been able to find one (even used) that was at a price I was willing to pay. I stumbled across these steel panels for the bins that were pretty cheap though, and thought I could build a stand for them with the pine 2x4s that have been sitting in my basement since we moved. This is the result. The back is held together with half-laps, with the crosspieces positioned so had enough wood to drill in to on each panel. I left the vertical pieces long at the bottom to act as tenons and to give me a place to put addition levelers. Pine Bin Organizer Back The base it constructed with some big ol' box joints, as well as half-lapped stabilizers and through tenon middle supports for the back. Pine Bin Organizer Base I made these on the table saw using a big box joint jig. F...

Spalted Maple Valet Glue-up

I found this 5/4 8" board at Farnsworth Lumber a couple months back. They threw it in the solar kiln for me and got it pretty dry so I started using it to make this valet last week. It's a continuous grain box with a drawer below (still working on that). The top is separated so there's a place for a phone. Spalted Maple Valet I was pretty happy with it when I was dry fitting it, but after glue up some slight gaps in the dovetails appeared and it went out of square by about 1/32". Not a huge deal but just annoying. Any sage advice for preventing these sort of problems? The dovetails were super tight before glue. Spalted Maple Valet Spalted Maple Valet

Finished Cherry End Tables

I put the last coat of finish on these late last week, got the tops attached and installed the knobs over the weekend. All done!

Two Bit Woodworker

Search This Blog