Finished Black Locust Plant Stands

I put the finish on these last weekend, and they're now sat in the living room awaiting the Great Spring 2019 Plant Rearrangement. The idea for these came from Jay Bates' Angled Half Lap Three Tier Shelf. The biggest change I made was reversing the side that the half-laps were on. This allowed me to rest the shelves on them, as I was worried that the amount of weight from the plants would be hard to support with just screws.

Another change was adding crosspieces, I was originally going to use wedged, through tenons here but liked this chamfered version enough to keep it.

These are just over four feet tall and 28 inches wide. The shelves are spaced every 15 inches, start at 14 inches deep at the bottom and narrow to eight inches deep at the top. They are secured to the half lap side pieces via tabletop fasteners and stainless steel screws. Black locust is very resistant to decay so they should have no problem being outdoors, but as added protection I poured some resin on the endgrain of the feet.

Comments

Pine Bin Organizer

More of a shop project (technically a basement project) but it's wood so I decided to post it up anyway. I've been looking for a bin organizer for awhile but I haven't been able to find one (even used) that was at a price I was willing to pay. I stumbled across these steel panels for the bins that were pretty cheap though, and thought I could build a stand for them with the pine 2x4s that have been sitting in my basement since we moved. This is the result. The back is held together with half-laps, with the crosspieces positioned so had enough wood to drill in to on each panel. I left the vertical pieces long at the bottom to act as tenons and to give me a place to put addition levelers. Pine Bin Organizer Back The base it constructed with some big ol' box joints, as well as half-lapped stabilizers and through tenon middle supports for the back. Pine Bin Organizer Base I made these on the table saw using a big box joint jig. F...

Spalted Maple Valet Glue-up

I found this 5/4 8" board at Farnsworth Lumber a couple months back. They threw it in the solar kiln for me and got it pretty dry so I started using it to make this valet last week. It's a continuous grain box with a drawer below (still working on that). The top is separated so there's a place for a phone. Spalted Maple Valet I was pretty happy with it when I was dry fitting it, but after glue up some slight gaps in the dovetails appeared and it went out of square by about 1/32". Not a huge deal but just annoying. Any sage advice for preventing these sort of problems? The dovetails were super tight before glue. Spalted Maple Valet Spalted Maple Valet

Finished Cherry End Tables

I put the last coat of finish on these late last week, got the tops attached and installed the knobs over the weekend. All done!

Two Bit Woodworker

Search This Blog