Skip to main content

Spalted Maple Valet

His birthday has come and gone so it's safe to say that this was a birthday present for my BiL now. After sanding it up I finished it with my usual method: boiled linseed oil, danish oil, wipe-on polyurethane.

Spalted Maple Valet
Spalted Maple Valet

The drawer dividers were friction fit. I was initially planning on adding a hidden compartment above the drawer and below the top, but there's and alignment issue with my dovetail jig and I lost too much height because of it. All the more reason to try hand-cut dovetails I guess.

Spalted Maple Valet Drawer
Spalted Maple Valet Drawer
Spalted Maple Valet Side
Spalted Maple Valet Side
Labels:

Comments

Post a Comment

Popular posts from this blog

Pine Bin Organizer

More of a shop project (technically a basement project) but it's wood so I decided to post it up anyway. I've been looking for a bin organizer for awhile but I haven't been able to find one (even used) that was at a price I was willing to pay. I stumbled across these steel panels for the bins that were pretty cheap though, and thought I could build a stand for them with the pine 2x4s that have been sitting in my basement since we moved. This is the result. The back is held together with half-laps, with the crosspieces positioned so had enough wood to drill in to on each panel. I left the vertical pieces long at the bottom to act as tenons and to give me a place to put addition levelers. Pine Bin Organizer Back The base it constructed with some big ol' box joints, as well as half-lapped stabilizers and through tenon middle supports for the back. Pine Bin Organizer Base I made these on the table saw using a big box joint jig. F...
Post a Comment
Read more

Spalted Maple Valet Glue-up

I found this 5/4 8" board at Farnsworth Lumber a couple months back. They threw it in the solar kiln for me and got it pretty dry so I started using it to make this valet last week. It's a continuous grain box with a drawer below (still working on that). The top is separated so there's a place for a phone. Spalted Maple Valet I was pretty happy with it when I was dry fitting it, but after glue up some slight gaps in the dovetails appeared and it went out of square by about 1/32". Not a huge deal but just annoying. Any sage advice for preventing these sort of problems? The dovetails were super tight before glue. Spalted Maple Valet Spalted Maple Valet
Post a Comment
Read more

Finished Cherry End Tables

I put the last coat of finish on these late last week, got the tops attached and installed the knobs over the weekend. All done!
Post a Comment
Read more